![]() ![]() ![]() Fehler bei der Mischerregelung im Modus mit unbenutzter Eingangsvariable "Istwert" und ohne Verknüpfung mit einem Ausgangspaar behoben.Die Texte "Laufzeitzähler" und "Restlaufzeitzähler" wurden auf "Restlaufzeit" geändert.CORA: Koppeln-Button kann nun auch in die Visualisierung eingebaut werden.Im Zuge dessen wurde auch teilweise die Auflösung verbessert Eingänge sind nun nicht mehr auf 2 Byte sondern auf 4 Byte limitiert.neues Format von CAN-Ausgängen implementiert, welches Werte mit 4 Byte überträgt (wird nur verwendet wenn beide Gegenstellen das Format unterstützen).alle Geräte die über die DL versorgt werden, werden nun bei einem Softwareneustart des Reglers ebenfalls neu gestartet.Fehler beim Übertragen und Empfangen von CAN-Bus Ausgängen behoben.* "xxx" signifies the firmware version you are intending to update to and needs to be the same wherever mentioned. When updating a controller with a version below 1.04, the controller must receive an intermediate update to version 1.04 before updating to a higher version. To do so, drag the file “UVR16x2_Vxxx.bin” onto your UVR16x2 controller (under the tab “Data administration”).Īttention: Please update your C.M.I.’s firmware first. With a firmware version of 1.20 or above, the C.M.I. ![]() or in the directory /UVR16x2_Vxxx/ * on the SD-Card.or in the directory /UPDATE/ on the SD-Card.Preferably in the SD-Card’s root directory (not in any sub-folders).The update is to be initiated with the file “StartBSUpdate_Bxxx_UVR16x2_Vxxx”*. If the version of your UVR16x2’s firmware is below 1.20 and/or its bootsector below 1.05, two files are necessary on the SD-Card: “UVR16x2_Vxxx.bin”* and “StartBSUpdate_Bxxx_UVR16x2_Vxxx”*. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |